Scanning; Switching The System On/Off - Leica HDS7000 User Manual

HDS7000, Scanning
3
3.1
Switch on proce-
dure
Switch off proce-
dure

Scanning

Switching the System On/Off

1. Setup the instrument as desired. Refer to chapter "2 Setting Up the Instrument"
for more information.
2. Check that the lens is clean.
3. Press and hold the ON/OFF button for a minimum of 0.3 seconds.
4. The power-up process starts and requires approximately 20 seconds to
complete. During the power-up process the vertical mirror will spin.
5. The system menu is shown on the display.
6. An audible signal sounds.
• Press and hold the ON/OFF button for a minimum 0.5 seconds.
• The display shows Shut down system. Please wait.
In the event of a system crash, press the ON / OFF button for at least 5 seconds. The
system switches itself off.
38