Adding A Keyfob - CADDX xGenConnect Installation And Programming Manual

If the card had been secured before (for example, using the keypad menu), the
card is ready to use.
Otherwise, if the card is new, or the system card security key has been changed
in the panel, perform the following steps to secure the card:
1. Press the Secure button. The button is automatically enabled after successful
saving of card data.
Note: Card Enable parameter must be checked.
Card securing process will start and an additional button will appear to allow
cancelling the process of securing the card or tag if needed.
2. Present the card or tag to any NXG-1832 / NXG-1833-EUR keypad in the
system. The keypad must display the main screen (screen saver is not
active).
Keep the card or tag close to the keypad for a few seconds until the relevant
message appears both on the keypad screen ("Card Secured, number") and
on the web page ("Securing Successful"). The keypad also generates a two-
tone sound to confirm the card is successfully secured.
The card is ready for use.
Note: You can also assign cards to users using the NXG-1832 / NXG-1833-EUR
keypad menus which may be more convenient as the card has to be presented
to keypad reader anyway. Adding a card or tag to an existing user via the keypad
menu will automatically secure the card, if not already the case. The keypad User
Card menu also allows you to sequentially add and secure multiple cards to
users. See NXG-183x-EUR Series Keypad User Manual for details.

Adding a Keyfob

1. Log in to the Web Server.
2. Click Settings.
3. Click Keyfobs.
60 xGenConnect Installation and Programming Guide