CADDX xGenConnect Installation And Programming Manual page 103

5. Select the user type that you want to apply to this user. Descriptions of each
type are available in xGen Reference Guide.
6. If the user type is not Custom, select the desired Partition Group and Door
Group.
7. Card number and Card Enabled parameters may be set.
not allow securing cards or fobs remotely. It is recommended to use the NXG-
1832 / NXG-1833-EUR keypad or panel web browser to assign cards to
users.
8. Click the Advanced tab.
9. You can set the start/end date and time for when this user will have access to
the system. This can be used to provide temporary user access. If Active is
selected on the previous tab then the end date and time on this screen will be
set to maximum.
10. You can program up to 4 levels of access for each user. Permission 1 is
applied when Schedule 1 is true.
The combination of one Permission and one Schedule is called a "Permission
Profile" (left drop-down menu). Permission Profile 1 is the highest level and will
override Permission Profile 2 when Schedule 1 is active. Refer to xGen
Reference Guide for more details.
To enable Permission Profiles the user type must be first set to Custom on the
Main tab.
xGenConnect Installation and Programming Guide
Note: Available for Custom user type only.
Note: DLX900 does
91