Table of Contents
Advertisement
•
A card must be properly secured, assigned to a User, and enabled. See
"Configuring cards or tags using the NXG-1832 / NXG-1833-EUR keypads"
on page 143 for details.
•
The user must have permissions to execute the desired operation (arming
away, arming stay, disarming).
•
The keypad must be configured to trigger the desired action when a card or
tag is presented. There are three card beep functions available (single,
double, and triple beeps), which can be configured separately for desired
actions. See NXG-183x-EUR Series Keypad User Manual for details.
In order to trigger the configured function, the card must be presented to the
keypad, preferably close to the center of the LCD screen, and the keypad must
be either in screensaver mode, or showing the main screen.
Note:
It is possible to configure the same card function for both arm and disarm
operation. If the partition is armed or in alarm, presenting the card will disarm it. If
the partition is disarmed, presenting the card will arm the partition. See
xGenConnect Door Access Programming Guide for more details.
Activate SOS Feature (NXG-1820-EUR only)
Touch the SOS button to display the SOS feature:
On this screen touch and hold the appropriate button for 2 seconds to activate
Manual Fire Alarm, Manual Medical Alarm, or Manual Panic Alarm.
Depending on how your system is programmed, the control room may receive
the corresponding event. Check with your control room to determine what action
will be taken.
If silent alarm is enabled, then the keypad will not display any signs that the panic
button was pressed.
xGenConnect Installation and Programming Guide
37
Advertisement
Table of Contents
