3. Go to Menu 22. UltraSync.
4. Enter a new 8 digit Web Access Passcode. All zeros disables UltraSync
remote access.
5. Enter the required details into your device/software. This will usual be your
xGenConnect serial number, Web Access Passcode, and a valid Username
and PIN code. The xGenConnect serial number can be found in the Device
Info menu.
6. Verify the UltraSync service is working by using your device/software to
connect your xGenConnect system.
Troubleshooting
•
Check the Web Access Passcode is correct. It cannot be 00000000.
•
Check there is a valid user and they have a First name, this will be the login
name.
•
Check the serial number is correct. It is printed on the xGenConnect module.
•
Check that the user permissions are currently valid.
See also "Appendix 2: App and Web Error Messages" on page 136.
Programming Instructions for Event Lists
Goal
Create segmented lists of events so Channels can selectively deliver event
messages.
Pre-conditions
None.
116
xGenConnect Installation and Programming Guide