Seagull Models YAKOVLEV YAK 3 Assembly Manual page 30

YAK 3
2) A scale pilot is included with this ARF.
he Pilot included itting well to the
cockpit. (or you can order others scale
pilot igures made by SG Models. hey
are available at SG Models distributors.)
If you are going to install a pilot igure,
please use a sanding bar to sand the base
of the igure so that it is lat.
3) Position the pilot igure on the can-
opy loor as shown. Use epoxy to glue
the base of the pilot igure to the cockpit
loor, please see pictures as shown.
110mm
30
Epoxy.
Instruction Manual.
4) Position the canopy onto the fuselage.
Trace around the canopy and onto the fu-
selage using a felt-tipped pen. Carefully
cut and remove covering material from
the fuselage where the canopy makes
contact, exposing the bare wood. hen
permanently glue the canopy in place
with epoxy glue or special "canopy glue".
Epoxy.
APPLY THE DECALS.
1) If all the decals are precut and ready to
stick. Please be certain the model is clean
and free from oily ingerprints and dust.
Position decal on the model where de-
sired, using the photos on the box and
aid in their location.
2) If all the decals are not precut, please
use scissors or a sharp hobby knife to cut
the decals from the sheet. Please be cer-
tain the model is clean and free from oily
ingerprints and dust. Position decal on
the model where desired, using the pho-
tos on the box and aid in their location.
INSTALLING BATTERY - RECEIVER.
1) Plug the servo leads and the switch
lead into the receiver. Plug the battery
pack lead into the switch also.
2) Wrap the receiver and battery pack in
the protective foam rubber to protect
them from vibration.