Transmission Sample Holders - Datacolor 650 User Manual

Below is an example of the correct installation of the spill tray and sample holder base:
NOTES
Exercise care when installing the base into the transmission compartment. The design is
very tight.
The spill tray is installed at the factory.
Install the base in the transmission compartment before attaching either of the sample
holders. No special tool is required for installation.
The base must be removed to make closed-case reflectance measurements.

Transmission Sample Holders

Two sample holders are provided to accommodate various types of transparent samples.
Solid Sample Holder
Two thumb screws provide the ability to adapt
the holder to samples of varying thicknesses.
This holder is used for transmission
measurements using the 650V.
Datacolor 650/600/400 User's Guide
Installed sample
Cuvette Holder (Liquid Samples)
This holder is designed for use with a 50mm X
10mm cuvette.
Accessing the Transmission Compartment • 29
holder base
Spill tray