Serial Cable Installation - Datacolor 650 User Manual

Serial Cable Installation

You can connect the instrument to the computer using either a serial cable or a USB cable.
Select one of them. This section provides instructions for using the serial cable.
NOTE
Do not connect both cables to the unit.
The serial cable is shown below:
1. Connect the 9-pin male connector on the serial cable to the RS-232C female
2. Connect the female connector on the serial cable to a serial communications port
3. If there is more than one serial port on the computer, make a note of the port
4. Tighten each connection securely to ensure proper signal.
See the Appendix for a description of the RS-232C connector pin assignments.
8 • Serial Cable Installation
connector on the rear panel of the instrument.
on the back of the computer.
being used. You may need to enter this information into the program.
Datacolor 650/600/400 User's Guide