Table of Contents
Advertisement
Radio Site Code
There are two methods of setting the radio site code:
a) Entering the site code from the telephone keypad (using 1's and 0's).
b) Commanding Homelink to "learn" the site code from a pendant.
a) To Enter Site Code From Keypad (Except for 4601UK-75/4901UK-60)
1.
Dial 92.
2.
Dial 11100001 (for example).
3.
Dial #.
You hear two short bleeps if you have entered the site code
successfully.
b) To Learn Site Code From Pendant
1.
Dial 93#. (Use 96# for Second Pendant Site Code)
2.
Press the pendant button within five seconds.
You hear two short bleeps if Homelink has learnt the site code
successfully.
Note: You can also set the radio site code using the PSION II Programmer.
Recorded Message
You can record a short voice message on Homelink that it will try to deliver
as part of its Speech Reports. The voice message can be up to 20 seconds
long.
The commands available are:
94#
Record speech
95#
Playback speech
To Record A Speech Message
1.
Dial 94#.
2.
Press Away on the Homelink unit.
Homelink switches its microphone on and turns the green Away lamp
off.
3.
Speak your message clearly. Remember to include enough information
to identify the caller.
4.
Press Away on the Homelink unit.
Homelink turns the microphone off and lights the green Away lamp.
(Note that if you do not press Away to end the recording Homelink will
turn the microphone off after 20 seconds.)
5.
Dial 95#.
Homelink plays back your recorded message through its speaker.
496758
Page 19
Advertisement
Table of Contents
