Table of Contents
Advertisement
Notes: 1. Remover power from the unit before fitting or removing links to jumpers 1 or
2. Changes do not take effect until you re-apply power.
2. Do not use these functions if you are using the unit in speech mode only.
Make sure there are no links fitted to jumpers 1 or 2.
6
Auxiliary connectors. See p8 of "PSION Programming Guide".
Connection
1. Plug the lead from the mains adaptor into the power socket at the back of
the Homelink unit.
The Power and Emergency lights glow. The
2. Plug the lead from the telephone adaptor cable into the socket marked
at the back of the Homelink unit.
3. Plug the lead from the telephone into the socket on the telephone adaptor
cable.
4. Refer to Chapter 6 and carry out any programming.
5. Break out the cable access tabs on the access panel as necessary, and
refit the access panel.
6. Plug the telephone lead from Homelink into the telephone socket on the
wall.
The
light should go out within a few seconds.
Homelink is free standing for shelf or table use. It may also be wall mounted.
Make sure there is a telephone socket and power point nearby. Ensure that
the user can reach Homelink quickly and easily.
Do NOT site Homelink:
•
On a soft surface, for example a carpet.
•
Near the floor.
•
Close to or on large metal structures.
•
Closer than one metre to mains wiring and metal water or gas pipes.
•
Inside steel enclosures.
•
Next to electronic equipment, particularly computers, photocopiers or
other radio equipment.
In addition, do not place anything other than a telephone on top of the unit,
and make sure that no liquids can spill onto it.
Page 12
4. SITING THE UNIT
496758
light flashes.
Advertisement
Table of Contents
