Triggers (2020Uk-01/02/03); 4601Uk-50 Radio Pendant; Setting Up; 4601Uk-75/4901Uk-60 Radio Pendants - Cooper Scantronic HOMELINK EXTRA Installation & Programming Manual

Social alarm
Table of Contents

Advertisement

Homelink operates with any of five standard Scantronic triggers. This
Chapter briefly describes each of them.
After physically installing a trigger you must set it to the correct radio site
code for each user. This is done by setting a row of small switches inside the
body of the trigger into a unique pattern for each site.
In addition, there are several switches to set within the trigger to make sure it
works correctly with Homelink. This Chapter tells you how to set the
appropriate switches within each type of trigger.

4601UK-50 Radio Pendant

The 4601UK-50 pendant is a small radio transmitter that the user wears
round his or her neck. The pendant is powered by a long life lithium battery.
To use the pendant, press the orange button on the front. The pendant
transmits a signal and briefly lights a small red lamp at the top of the case.
CAUTION: The pendant is splash resistant, but is not designed to be
immersed in water.
Once set to the Alarm Site Code on switches 1 to 8, the pendant can be
programmed by switches 9 to 12 to give either an alarm signal or a PA
signal.
When used as a PA trigger Homelink starts dialling immediately, without
giving any audible tones or changing the status of any LEDs. Once Homelink
establishes the call, the speech path is one way only: from Homelink to the
called number.

Setting Up

1.
Undo the two screws on the back of the device and gently pull the two
halves of the case apart
2.
Set switches 1 to 8 to the radio site code.
3.
Either:
Set switches 9 to 12 to the following pattern for an Alarm signal:
OR Set switches 9 to 12 to the following pattern for a PA signal:
4.
Put the two halves back together, and insert and tighten the screws. Do
not overtighten.
Note: Site codes and types have been factory preset in 4601UK-50 pendants.

4601UK-75/4901UK-60 Radio Pendants

These pendants have no dip switches and therefore can only be learned by
method (b), see page 19. The units are sealed and the batteries are not
replaceable.
5. TRIGGERS
496758
Page 13

Advertisement

Table of Contents
loading

This manual is also suitable for:

Scantronic homelink extra ii

Table of Contents