Table of Contents
Advertisement
Programming From A Local Telephone
Homelink is designed to let you change parts of its programming by using a
DTMF telephone connected to the Telephone Programming socket under
the access panel.
Using this method you can program the following:
•
Telephone numbers
•
Account numbers
•
Reporting Format
•
Security Code
•
Radio Site Code First Pendant
•
Radio Site Code Second Pendant
•
Recorded Messages
•
Load default settings.
Using A Telephone For Programming
SAFETY WARNING: Disconnect Homelink from the telephone network
before opening the access panel.
To program Homelink using a telephone:
1.
Undo the screw holding the access panel onto the base of Homelink.
2.
Remove the access panel.
3.
Take the cable from the telephone and plug the connector into the
Local Programming socket inside Homelink (see Fig 3.1).
4.
Lift the phone handset
Homelink lights all four lights on its front panel. The lights remain ON
while the handset is off-hook to show that Homelink is in programming
mode.
5.
Enter the Security Code, default "7890".
Homelink gives two short bleeps if you have entered the correct
Security Code.
6.
Use the telephone keypad to enter the new programming commands.
Homelink gives two short bleeps if you enter a command correctly, one
long bleep if you enter a command incorrectly.
7.
Replace the handset and disconnect the telephone from Homelink
when you have finished programming.
Homelink turns off the Line Fault and Away lights.
8.
Always test the new program on the Homelink unit.
Page 16
6. PROGRAMMING
496758
Advertisement
Table of Contents
