Table of Contents
Advertisement
Using a 4601UK-50 For a Low Temperature Alarm
The 4601 pendant can be programmed to start a Low Temperature alarm by
setting the pendant's site code to the Homelink's Low Temperature Site
Code (see "2. Technical Description - Radio Site Code".)
Setting Up
1.
Undo the two screws on the back of the device and gently pull the two
halves of the case apart
2.
Set switches 1 to 8 to the radio Site Code.
3.
Set switches 9 to 12 to the following pattern:
4.
Put the two halves back together, and insert and tighten the screws. Do
not overtighten.
4604 Door Contact
The Door Contact sends a signal whenever the door or window it is attached
to opens or closes. Homelink reports this signal while in Away mode.
Siting
Fix the body of the detector to the door or window surround. Fix the magnet
to the door or window itself.
Setting Up
1.
Open the case.
2.
Set switches 1 to 8 to the radio site code.
3.
Set switches 9 and 10 to the following pattern:
4.
Close the case.
4670-20 Pull Cord
This trigger looks like a switch with a long cord (like a bathroom light switch).
When the user pulls the cord the 'switch' sends a radio signal to the
Homelink.
Siting
Fix the pull cord unit to a ceiling. Good locations are above a bath, toilet or
bed headboard.
Setting Up
1.
Undo the screw on the front of the case and lower the lid.
2.
Set switches 1 to 8 to the radio site code.
3.
Set switches 9 to 12 to the following pattern:
4.
Close the lid, replace the screw and tighten it. Do not overtighten.
Page 14
496758
Advertisement
Table of Contents
