Table of Contents
Advertisement
Unpacking And Preparation
1. Take the Homelink unit out of its packaging. (Store the packaging for
future use.)
2. Make sure the following are present:
•
Homelink unit.
•
Power supply adaptor.
•
Pendant.
•
Telephone cable.
•
Telephone adaptor cable (UK).
3. Turn the Homelink unit until you can see the base and identify the access
panel.
4. Undo the screw holding the access panel on and remove the panel.
5. Look inside the Homelink unit and identify the items shown below.
1
Cable slots.
2
Psion Programmer socket.
3
Local telephone programming socket.
4
(HLX II only). Emergency Call repeat timer jumper. Fit link to enable.
When enabled, Homelink repeats the Emergency Call message after
15 minutes if no one has pressed the Call Cancel (Help Arrived) button.
This jumper is inactive if Call Cancel jumper has no link fitted.
5
(HLX II only). Call Cancel (Help Arrived) button enable jumper. Fit link
to enable. When enabled, pressing the yellow button on the front of the
Homelink Extra II starts a Call Cancel (Help Arrived) message.
3. INSTALLATION
Fig. 3-1 Internal Connectors
496758
1
2
3
4
5
6
Page 11
Advertisement
Table of Contents
