Table of Contents
Advertisement
To Change Account Number 1 (Example)
1.
Dial 11.
2.
Dial the new Account Number.
3.
Dial #.
You hear two short bleeps if you have entered the Account Number
correctly.
Reporting Format
You can change the reporting format from the telephone keypad. The
commands for changing the report format for each telephone number are:
20
Reporting format for all numbers
21
Report format for telephone number 1
22
Report format for telephone number 2
23
Report format for telephone number 3
24
Report format for telephone number 4
To Change Report Format for Telephone Number 1 (Example)
1.
Dial 21.
2.
Dial 01 for Scancom format or
40 for Speech only.
3.
Dial #.
You hear two short bleeps if you have entered the command correctly.
Changing Security Code
When Homelink is delivered from Cooper Security Ltd its security code is set
to "7890". To make sure that unauthorised people cannot change a client's
Homelink programming you should change the security code as soon as
possible.
To Change The Security Code
1.
Dial 91.
2.
Dial the new security code (for example 1234)
3.
Dial #.
You hear two short bleeps if you have changed the security code
successfully.
Loading Defaults
You may wish to completely reprogram a Homelink unit back to the settings
it had when it left the factory. For example, you may wish to do this when
transferring a Homelink unit from one client to another.
To Load Default Settings
1.
Dial 0 * * #.
After a few seconds Homelink gives two short bleeps if it has
successfully loaded the default settings.
Page 18
496758
Advertisement
Table of Contents
