4609 Smoke Detector; Siting; Setting Up; 4608 Movement Detector - Cooper Scantronic HOMELINK EXTRA Installation & Programming Manual

Social alarm
Table of Contents

Advertisement

4609 Smoke Detector

The Smoke Detector sends a radio signal to the Homelink when it detects
smoke. The user does not have to do anything to activate it.

Siting

Fix the smoke detector to a ceiling, not less than 800mm from the wall edge.
Good locations are:
Landing ceiling above the staircase.
Lounge ceiling.
Hall ceiling.
Do not fix on a kitchen ceiling.
Note: Don't smoke cigarettes nearby, or leave the kitchen door open while cooking;
these things can trigger the Smoke Detector.

Setting Up

1.
Open the hinged lid of the case.
2.
Set switches 1 to 8 to the radio site code.
3.
Set switches 9 to 12 to the following pattern:
4.
Remove jumper (if fitted) from link J2.
5.
Close the lid.

4608 Movement Detector

The Movement Detector 'sees' the warmth from a person's body. Whenever
a warm object moves within range, the Detector sends a radio signal to
Homelink. Homelink can be programmed to make an emergency call if there
has not been any movement for a preset time.
Siting
Place the movement detector within a room so that it can monitor an area
where there is frequent movement. A good location is in a corner, against
the ceiling and facing a door.
Do not site the movement detector facing a window, a radiator or other heat
source.
Note: A pet may trigger the Movement Detector as well as a person.
Setting Up
1.
Open the case and lower the lid.
2.
Set switches 1 to 8 to the radio site code.
3.
Set switches 9 and 10 to the following pattern:
4.
Close the case.
496758
Page 15

Advertisement

Table of Contents
loading

This manual is also suitable for:

Scantronic homelink extra ii

Table of Contents