Table of Contents
Advertisement
Special Commands
When using the telephone to program Homelink the following special
commands are available:
*0
Abort current command (Homelink gives one long bleep after
you issue this command.)
*1
Insert dial pause
*2
Insert dial tone wait
**
Insert the "*" character itself
*#
Insert the "#" character itself
These commands are useful for making sure that Homelink can dial
telephone numbers successfully.
Telephone Numbers
Using the telephone keypad you can change any of the four telephone
numbers stored in Homelink. You must type a command to access each of
the numbers. The commands are:
01
Telephone Number 1
02
Telephone Number 2
03
Telephone Number 3
04
Telephone Number 4
Note: Do not program the telephone numbers of the emergency services (for
example "999").
To Change Telephone Number 1 (Example)
1.
Dial 01
2.
Dial the new telephone number, for example: *1 012 3456 789
3.
Dial #
You hear two short bleeps. The telephone number is now changed.
Account Numbers
Note: Account numbers are NOT required if you are programming Homelink to use
Speech Only reporting format.
You can change any of the four Account Numbers from the telephone
keypad. Each Account Number has its own command:
10
All four account numbers programmed the same
11
Account Number 1
12
Account Number 2
13
Account Number 3
14
Account Number 4
496758
Page 17
Advertisement
Table of Contents
