APRILIA RS 125 Euro 4 Service Manual page 79

RS 125 - Tuono 125 - Euro 4
•
Check fastening of the chassis - engine ground cable.
•
Check the flywheel connection.
•
Check the lambda connection (with security Lock).
•
Check that lambda probe cable is correctly connected.
•
Check that the "ABS" connector is correctly inserted.
•
Check that the front and rear "ABS" sensors are correctly connected.
The installation is shown with the vehicle ideally
divided into three parts:
1. Front section
2. Central section
3. Rear section
Front side
A TABLES - FRONT HEADLIGHT ASSEMBLY
TABLE A1 - Pre-fitting
1. Daylight running light (5W).
2. Cable grommet.
3. Light relay.
4. Low beam light.
5. Headlight wiring harness.
6. High-beam light.
TABLE A2 - Headlight cable routing: LH side
1. Daylight running light (5W).
2. Cable grommet.
3. Low beam light.
4. LH daylight running light wiring harness.
5. LH low beam light wiring harness.
Electrical system
ELE SYS - 79