Table of Contents
Advertisement
ASSEMBLY
Assembly requires two persons. Place all parts of the rower in a cleared area and remove the packing materi-
als. Do not dispose of the packing materials until assembly is completed.
In addition to the included tool(s), assembly requires a Phillips screwdriver
and an adjustable
wrench
.
As you assemble the rower, use the drawings below to identify small parts. The number in parentheses below
each drawing is the key number of the part, from the PART LIST near the end of this manual. The number fol-
lowing the parentheses is the quantity needed for assembly. Note: If a part is not in the hardware kit, check
to see if it has been preassembled.
M8 x 16mm
M8 Curved
M8 x 23mm
M8 x 26mm
Washer (74)–2
Washer (76)–2
Washer (77)–1
Washer (75)–6
Jam Nut
M8 Locknut
M3 x 12mm
M4 x 25mm
(78)–1
(73)–4
Screw (42)–2
Screw (84)–2
M8 x 15mm Hex
M8 x 55mm Hex
M8 Carriage Bolt
Screw (86)–4
Screw (83)–2
(82)–2
1/2" x 127mm Hex Bolt (88)–1
5
Advertisement
Table of Contents
