Table of Contents
Advertisement
Filter Templates
Filter templates may be created as a pass all, pass by or deny by. Pass by and deny by templates
may include multiple matching options to filter traffic. The options are considered by the system as (and)
options. Thus, for traffic to pass or be denied it must match all defined options. Once a template is
created it will appear on the Create Config Map panel and may be used to create an ingress or egress
filter. Template options may be modified when applied to a config map. Any option modification made will
not change the original template. It is advisable to rename a filter applied to a config map if the original
template options were modified.
1. Select Filter Templates on the Packet Broker Configurations panel.
The Filter Templates panel will be displayed.
2. Select Create Template.
The Create New Filter Template panel will be displayed.
3. Enter the template name. If no name is entered the system will automatically apply a name as follows,
tmplt, tmplt(2), tmplt(3), etc.
4. Enter the description, optional.
5. Select the Template Type, Pass All, Pass By or Deny By.
6. If pass by or deny by was selected in Step 5, the options will be displayed as follows.
Source MAC Address / Source MAC Mask
Destination MAC Address / Destination MAC Mask
Ether Type
Source IPv4 Address / Source IP Mask
Destination IPv4 Address / Destination IP Mask
Source IPv6 Address / Source IP Mask
Destination IPv6 Address / Destination IP Mask
Inner VLAN ID
Outer VLAN ID
DSCP
IP Protocol
L4 Source Port or Range
L4 Destination Port or Range
7. Select Save Template once all desired option modifications have been completed.
8. The new filter template will appear on the Filter Templates panel.
Garland Technology | 716.242.8500 | www.garlandtechnology.com
Copyright © 2023 Garland Technology, LLC. All rights reserved.
XtraTAP | P10GxxFE-X | 4.22.1
IPv6 is not supported for this model
IPv6 is not supported for this model
User Guide
38
Advertisement
Table of Contents
