Table of Contents
Advertisement
3. Enter the Username.
4. Enter the Password.
5. Select Test.
The GUI will display the results of the test, "Authentication Test Successful". As well as
messages for "authentication:Success", authorization:Success" and
"authorization:group:abcdef.
TACACS Ping Test
This option may be used to verify the network connectivity from the unit to the TACACS server.
The TACACS Ping option will be active only if TACACS authentication has been previously enabled.
1. Select TACACS 2 Ping.
The GUI will display the results of the ping, "TACACS 2 Ping Successful".
Network Settings
Upon the initial turn up via the serial interface the IPv4 address, IPv4 gateway, IPv6 address and IPv6
gateway may have been already established. The IPv4 and IPv6 management interfaces may be
enabled or disabled independently as well as both enabled or disabled simultaneously. If the IPv4
and IPv6 management interfaces are disabled simultaneously, access is only allowed via the serial
interface. Any modifications made to any setting option will cause GUI disruption for about 60 seconds.
Also note that modifying the management interfaces may cause network disruption if prior consideration
and planning have not been performed.
The default system network configurations are as follows:
IPv4 enabled
IPv4 address 10.10.10.200
IPv4 gateway 10.10.10.1
IPv6 is disabled.
Via the GUI, the following options may be displayed, modified, enabled or disabled.
IPv4 Enable/Disable
IPv6 Enable/Disable
SSL Certificate Loaded
Using Uploaded SSL Certificate
1. Select Network Settings.
The Network Settings panel will be displayed with the current configuration.
IPv4 / Disable
1. Deselect Enable IPv4.
Garland Technology | 716.242.8500 | www.garlandtechnology.com
Copyright © 2023 Garland Technology, LLC. All rights reserved.
IPv4 Address
IPv4 Gateway
IPv6 Address
IPv6 Gateway
User Guide
XtraTAP | P10GxxFE-X | 4.22.1
16
Advertisement
Table of Contents
