Add Ssl Certificate - Garland P10GMSFE-5 User Manual

2. Select Save.
If the IPv6 management interface has not been enabled the GUI will display a
message "Disabling IPv4 and IPv6, GUI will disconnect. Are you sure?
3. Select OK.
IPv4 Enable
1. Select Enable IPv4.
2. Enter the desired Address.
3. Enter the desired Gateway.
4. Select Save.
IPv6 Enable
1. Select Enable IPv6.
2. Enter the desired Address.
3. Enter the desired Gateway.
4. Select Save.
IPv6 Disable
1. Deselect Enable IPv6.
2. Select Save.
If the IPv4 management interface has not been enabled the GUI will display a
message "Disabling IPv4 and IPv6, GUI will disconnect. Are you sure?
3. Select OK.

Add SSL Certificate

Uploading a custom SSL certificate involves two files. The cert.pem file and key.pem file. The unit will
validate these files during the upload. If the files do not match or one of the files are corrupted the unit will
abort the upload.
1. Select Add SSL Certificate.
The Select Certificate and Select Key File panel will appear.
2. Select Choose File for Select Certificate.
3. Select the desired cert.pem file.
4. Select Open.
5. Select the Choose File for Select Key File.
6. Select the desired key.pem file.
Garland Technology | 716.242.8500 | www.garlandtechnology.com
Copyright © 2023 Garland Technology, LLC. All rights reserved.
User Guide
XtraTAP | P10GxxFE-X | 4.22.1
17