Table of Contents
Advertisement
The Packet Broker Configurations panel will be displayed.
2. Select Create Config Map.
The Create Config Map panel will be displayed. Any previously created load balancing groups
or filter templates will be displayed along with the new options. Any port shaded gray can be
used for a config map, any port shaded black may not be used.
3. Select the Name pencil icon to apply a name, optional. If no name is entered the system will
automatically apply a name to the config maps as follows, map, map(1), map(2) etc.
4. Place the cursor in the Name panel and enter the name.
5. Select the Check to apply.
6. Select the Description pencil to apply a description, optional.
7. Place the cursor in the Description panel and enter the description, optional.
8. Select the Check to apply updates.
Ingress
1. Add an ingress port(s) 1 and/or 2 by placing the cursor on the desired port. Select with the left mouse
button. Drag the port to the Ingress panel and release. Ports may be added in any combination. If
ports 1 and 2 are added, then the traffic from the ports will be aggregated.
Figure 5 Ingress
Garland Technology | 716.242.8500 | www.garlandtechnology.com
Copyright © 2023 Garland Technology, LLC. All rights reserved.
User Guide
XtraTAP | P10GxxFE-X | 4.22.1
29
Advertisement
Table of Contents
