Sweepings Container - HAKO Citymaster 90 Instruction Manual

Maintenance and Care

5.9.13 Sweepings container

Checking the fill level, sweepings
container
Unlock the filter case and pivot towards
the back.
Note: If there is a hand-held suction
hose (1144) on the device, it must be
pivoted 90° outwards.
The following tasks must be performed
before emptying the sweepings
container:
• Agitate the filter system.
• Unlock the filter case and pivot it to-
wards the rear, remove and clean
the coarse particle sieve.
• Clean the dirt deposits in the filter ca-
se.
• Remove the bottom part with the
scraper.
• Reinsert the coarse particle sieve.
• Pivot the filter case back to its origi-
nal position and lock it in place pro-
perly with the fastening device.
Emptying the sweepings container
The fastening device (Fig. 26/1) must
always be locked. The pivoting lever
(Fig. 26/7) must always be pushed in
fully. It serves to prevent the filter case
turning the wrong way.
• Raise the sweepings container (Fig.
26/6).
• Open the container flap (Fig. 26/3)
by means of the lever (Fig. 26/5).
• Pull the container flap up and lock in
place with the hook (Fig. 26/4).
• The waste material slides down out
of the device.
• When the container is empty, the le-
ver (Fig. 26/5) must engage on clo-
sing the container flap.
Positioning the slider on the suction
turbine
When using the hand-held suction hose
(Fig. 26/8), the slider (Fig. 26/9) is in the
closed position, as illustrated in the
diagram. The default setting of the
slider is open.
2
7
3
4
5
9
8
Fig.26
1
6
61