Table of Contents
Advertisement
Operation
Control lamp for drive direction indi-
cator (Fig. 9/6)
It lights up when the indicator is on and,
at the same time, serves as a function
control lamp. Fast flashing indicates
defect indicators.
Control lamp for sweepings
container (Fig. 9/7)
It lights up when the sweepings
container is not in its working position.
Control lamp for coolant tempera-
ture (Fig. 9/8)
The control lamp lights up when the
coolant is too hot or the coolant level in
the fluid reservoir has dropped below
28
the minimum marking. Switch off the
engine immediately and determine the
cause.
Control lamp for engine oil pressure
(Fig. 9/9)
It lights up when a fault occurs in the oil
pressure system during operation.
Switch off the engine immediately,
allow to cool down and determine the
cause.
Switch off the engine and check the
engine oil level.
Control lamp for battery charge
(Fig. 9/10)
It lights up when starting the vehicle.
When the engine has started, it must go
out.
Control lamp for preheating device
(Fig. 9/11)
It must light up when preheating the
cold engine. Preheat for approx. 5
seconds then start the engine
immediately.
For safety reasons, the driver's
seat is equipped with a seat
contact switch. The engine can
only be started when the driver
is seated on the driver's seat.
Advertisement
Table of Contents
