Table of Contents
Advertisement
4. Remove the FFC guard (DC-HEAD), then disconnect the flexible flat cable from the connector
(CN601) on the MA-201 board.
5. Remove the two screws (BVTT2.6 x 5), then remove the MD top chassis and three head springs.
n
When removing the MD top chassis, slowly remove it in the direction of the arrow A so that the
head springs do not pop out.
6. Release the lock arm in the direction of the arrow B, then open the door block assembly in the
direction of the arrow C.
7. Remove the heat sink in the direction of the arrow D.
8. Remove the two screws (PSW3 x 8), then remove the thermal head.
BVTT
2.6
5
PSW3
Heat sink
Thermal head
Door block assembly
UP-D898DC
MD top chassis
A
8
Head springs
D
C
Cam shaft
BVTT
2.6
5
FFC guard (DC-HEAD)
Flexible flat cable
CN601
MA-201 board
Lock arm
B
3-21 (E)
Advertisement
Table of Contents
