Table of Contents
Advertisement
3-7. SW-1703 Board
1. Remove the cabinet. (Refer to Section 1-5.)
2. Remove the MD general assembly (DC). (Refer to Section 3-2.)
3. Remove the DC block assembly. (Refer to steps 3 and 4 in Section 3-6.)
4. Remove the screw, then remove the SW-1703 board.
5. Disconnect the two harnesses from the connectors (CN901 and CN903) on the SW-1703 board.
SW-1703 board
PSW
3
8
6. To install, reverse the removal procedure.
3-10 (E)
DC block assembly
CN903
CN901
Harnesses
UP-D898DC
Advertisement
Table of Contents
