Md General Assembly (Dc) - Sony UP-D898DC Service Manual

3-2. MD General Assembly (DC)

1. Remove the cabinet. (Refer to Section 1-5.)
2. Remove the spring (rod).
3. Remove the rod stopper (DC), then remove the switch rod (DC) in the direction of the arrow.
4. Disconnect the flexible flat cable from the connector (CN601) on the MA-201 board.
5. Disconnect the three harnesses from the connectors (CN904, CN905 and CN907) on the SW-1703
board.
6. Remove the three screws, then remove the MD general assembly (DC).
Spring (rod)
MD general
assembly (DC)
Switch rod (DC)
Rod stopper (DC)
7. To install, reverse the removal procedure.
n
Attach the sprint (rod) paying attention to its direction.
3-2 (E)
BVTT
2.6 5
Flexible flat cable
SW-1703 board
CN907
CN904
CN905
MA-201 board
Harnesses
CN601
Flexible
flat cable
UP-D898DC