Draining The Hot Water Tank - Newco CX TOUCH Manual

DRAINING THE HOT WATER TANK

Tank holds approximately 1 US gallon.
Caution- The water is extremely hot and can cause harmful burns, unless the tank is left to
cool. Do not store in freezing conditions as residual water may remain in machine.
METHOD 1
TO DRAIN
1. Unplug machine and remove waste bin. Allow machine to cool before proceeding.
2. Reaching up into the machine from where the waste bin sits, locate the tube clip on the
left side of the opening. Follow the tube up to locate the drain tube bracket.
3. Push the tubing up to release it from the bracket. You may need to follow the bracket to
the right and push up on the tube from the right side to fully release the drain tube.
4. Pull the tubing down and out to the front of the machine.
5. Remove the tube plug using pliers, then aim end of tube to where you are draining the
water. Push up on tube clip to open tube.
TO REPLACE
1. Once the tank is fully drained, tighten the tube clip and insert the drain plug
2. Feed the tube back up into machine, starting from right side of the tubing.
3. Locate the tubing bracket and line tube up with bracket.
4. Using your fingertips, press on the tube and roll it down into the bracket until secure.
5. Ensure tube clip is tucked away on the left side of the tank plate so that it does not interfere
with brewing mechanism.
METHOD 2
TO DRAIN
1. Unplug machine and remove waste bin. Allow machine to cool before proceeding.
2. Remove top cover of machine.
3. Locate drain tube and drain tube bracket.
4. Starting on the left side, pull drain tube up out of the bracket. Once free, feed the drain
tube down and out to the front of the machine.
5. Remove the tube plug using pliers, then aim end of tube to where you are draining the
water. Push up on tube clip to open tube.
TO REPLACE
1. Once the tank is fully drained, tighten the tube clip and insert the drain plug.
2. Feed the tube back up to top of machine, starting from right side of the tubing.
3. Line the tubing up with the drain tube bracket, then, starting on the right side, push and
roll down to secure tubing into bracket.
4. Ensure tube clip is tucked away on the left side of the tank plate so that it does not interfere
with brewing mechanism.
5. Replace top cover of machine.
Drain Tube Bracket
Image 1
See Image 2.
See page 30.
See Image 1.
See Image 2.
Tube Plug
Technical Service: 1-800-556-3926
MANUAL PN 782389 REV 20230126MMF
Tube Clip
Image 2
See Image 1.
29