Newco CX Touch Programming Instructions

Programming Instructions (Cont'd)

SECONDARY PROGRAMMING MODE (SERVICE MENU)

RECIPES AND CALIBRATION
Choc Auger Cal-- remove whipper chamber
and hold a 12 ounce plastic cup under the left
auger dispense spout, and with the "Choc
Auger Grams" value selected press "Start
Cal Cycle" button to start calibration
countdown period. After cycle has completed
use the + and - buttons to toggle the value,
increasing or decreasing value until the
display number matches the amount of the
Milk Cal-- remove whipper chamber and hold
a 12 ounce plastic cup under the left auger
dispense spout, and with the "Milk Auger
Grams" value selected press "Start Cal
Cycle" button to start calibration countdown
period. After cycle has completed use the +
and - buttons to toggle the value, increasing
or decreasing value until the display number
matches the amount of the powder measured
in grams.
TAP 3 TIMES ON CENTER OF TOP BAR
THEN TAP 3 TIMES ON CENTER OF
BOTTOM BAR
TO ENTER SECONDARY PROGRAMMING
MODE
IF A BREWING ICON IS ACCIDENTLY
TOUCHED USE THE RETURN ARROW TO
RETRY
Mix Bowl Cal--, Insert a measuring
container capable of holding 32 or more
ounces of water under delivery area of
machine, and with the "Mixing Bowl Cal oz"
value selected press "start "Cal Cycle"
button button to start calibration countdown
period . After cycle has completed use the +
and - buttons to toggle the value,
increasing or decreasing value until the
display number matches the amount of the
water measured in Ounces.