Newco CX TOUCH Manual page 15

MANUAL PN 782389 REV 20230126MMF
SETUP
Please note that Newco takes time to develop the default settings
for the brewer.
WATER TEMPERATURE
This entry allows the user to set the brewing temperature within the
range of 180°F to 205°F, with the default set at 200°F.
Higher altitudes: See page 11 for recommended brewing
temperatures.
WASTE BIN SIZE
This entry represents the number of pods that the waste bin will hold
before signaling that the waste bin is full. This can be set between
2 and 50, with the standard waste bin capacity being 30 pods. This
count can also be turned off, if you are using a special ordered
pass through waste bin (PN 780081).
AIR BLOW STRENGTH
This entry sets how strong the air pump pushes air, ranging from 3 to 10.
Note: Too high of an air strength may result in a broken pod.
AIR BLOW TIME
This entry changes how long the air pump runs to drain the remaining brew from the pod
chamber. This is shown in seconds, and can be set anywhere between 2 and 15 seconds.
WATER FILTER SIZE
This should be set to OFF, unless an external water filter has been installed on the water line.
The CX Touch can accommodate filter sizes between 500 and 3000 gallons. Remaining
gallons for the water filter can be tracked, which is shown on the Maintenance screen.
See Page 13.
CALL FOR SERVICE NUMBER
Allows for Servicer contact information to be entered, up to 34 alpha or numeric characters.
TOUCHLESS
Allows the user to choose between On (Touchless only), Off, or Combined modes.
SET DC PUMP SPEED
Note: Changing the pump speed will effect the speed at which water flows through the
brewing mechanism. Water flow speed could negatively effect drink taste profile, and may
cause pods to break. It is not recommended to change this setting.
ENERGY SAVE MODE
OFF
Power stays on, and hot water tank remains at brewing temperature.
SEMI
Hot water tank temperature set point is reduced to 180°F until any interaction is detected.
FULL
Hot water tank heater is disabled until any interaction is detected.
Note: After 72 hours of non-use, the heater will automatically turn off. Any interaction will turn
the heater back on.
ENERGY SAVE TIME
Allows the user to set when selected energy save mode is enabled. The range is 0.5-4.0 hours
in 0.5 hour increments.
15
Technical Service: 1-800-556-3926