Installation - Dantherm HCH 5 MKII Manual

INSTALLATION & SERVICE MANUAL FOR PROFESSIONALS
Installation: Control system strategy
Warranty claims
Use of an appliance outside the specified conditions and contrary to its intended use will re-
sult in loss of all warranty claims. The warranty is limited to devices installed solely by trained
and certified personnel.
Ducts The ducts connected to the units must at minimum be on the same size as the duct connec-
tors or bigger. The measurements can be seen on page 30.
Dimensioning of the ducts and sound mufflers must be in conformity with national standards
and guidelines directives in applicable current building act. For any kind of support and
instructions contact your Dantherm-distributor.
Noise and vibrations from the unit to the ducts must be minimized. This can be done by
installing sound attenuators on both supply and exhaust air sides.
Hanging ducts. The ducts must not "hang" from the unit without support.
ready for occupation, which means that the house is clean and dry. This is to pre-vent any
construction dust and condensed water from depositing in the ducting system and to pre-
vent any sanitation inconvenience from the ventilation units later on.

Installation

The ducts must be dimmed and the units must not be connected until the house is
31