Parameters/Address Space; Parameters - Siemens SIMATIC ET 200SP Manual

Parameters/address space

4.1

Parameters

Parameters of the DQ 8x24VDC/0.5A HF
Specify the module properties with the various parameters in the course of your STEP 7
configuration. The following table lists the configurable parameters. The effective range of
the configurable parameters depends on the type of configuration. The following
configurations are possible:
● Central operation with an ET 200SP CPU
● Distributed operation on PROFINET IO in an ET 200SP system
● Distributed operation with PROFIBUS DP in an ET 200SP system
When assigning parameters in the user program, use the "WRREC" instruction to transfer
the parameters to the module by means of data records (see chapter Parameter assignment
and structure of the parameter data record (Page 35)).
Table 4- 1 Configurable parameters and their defaults (GSD file)
Parameter
Diagnostics
No supply voltage L+
Diagnostics
Short-circuit to ground
Diagnostics:
Short-circuit to L
Diagnostics
Wire break
Channel activated
Digital output module DQ 8x24VDC/0.5A HF (6ES7132-6BF00-0CA0)
Manual, 12/2017, A5E03576680-AE
Value range
Disable
Disable
•
Enable
•
Disable
Disable
•
Enable
•
Disable
Disable
•
Enable
•
Disable
Disable
•
Enable
•
Enable
Disable
•
Enable
•
Default Configuration
in RUN
Yes
Yes
Yes
Yes
Yes
Scope with configuration software,
e.g., STEP 7 (TIA Portal)
GSD file GSD file
PROFINET IO PROFIBUS DP
Channel Channel
Channel
Channel
Channel
Channel Channel
Channel Channel
4
1
17