Ats Status Menu - Kohler 14RCA Instructions Manual

3.15 ATS Status Menu

ATS menus appear if a Model RXT transfer switch is connected to the generator set. If no transfer switch is connected, or
another model ATS is connected to the engine start connections, Remote ATS is displayed on the ATS Status screen.
The ATS Status menu displays Model RXT transfer switch and source information.
The voltage shown in these menus can be calibrated. Follow the safety precautions at the beginning of this manuals. Use a
voltmeter to measure the line-to-line voltage and follow the instructions in Figure 43 to calibrate the voltage readings.
ATS - - >
Status
Figure 43 ATS Status Menu, with Calibration
54
ATS Position:
Normal
Normal Status:
Not/Acceptable
Emerg. Status:
Standby
Single-phase
Normal Volts:
240.0 V
Normal Freq.:
60.0 Hz
Emerg Volts:
240.0 V
Emerg. Freq.:
60.0 Hz
Reset
Calibration
<- - Return
Note:
If there is no Model RXT transfer switch connected to the
generator set, Remote ATS is displayed and the other
screens on this page do not appear.
Note:
Sample data shown.
Three-phase
Normal Voltage:
L1- L2 240 V
Normal Voltage:
L2- L3 240 V
Normal Voltage:
L3- L1 240 V
Normal Freq.:
60.0 Hz
Normal Rotation:
Similar screens appear for the
emergency source.
Reset
Calib? No
Reset
Calib? Yes
tp6810
TP-7092 11/22