Changing Settings - Kohler 14RCA Instructions Manual

3.5

Changing Settings

Some settings can be changed from the controller keypad. The controller settings and generator set output are factory -set and
should not require field adjustment under normal circumstances. Check and adjust the settings and/or output when:
•
The controller has been replaced.
•
The voltage requires adjustment for a particular application.
•
Troubleshooting generator set problems.
Have controller setup and adjustment performed only by an authorized dealer or authorized representative.
The following procedure explains how to change settings. See the Changing Settings section for an example using the Date
and Time settings.
Note:
Use caution when navigating the controller menus. In some menus, pressing the Select button can enable editing of the controller
settings. Changing the settings to incorrect values can adversely affect generator set operation or render the unit inoperable.
Procedure to Change Settings
1. Press the Select button to enter the main menu.
2. Press the down arrow button until the desired menu is displayed. The Genset System menu is used for this example.
See the Main Menu section.
3. Press the Select button to enter the genset system displays. See Figure 34.
4. Press the down arrow button to step through the generator set system settings.
5. To change any of the genset system settings, press the Select button. The selected setting flashes.
6. Press the up or down arrow buttons to increase or decrease the setting.
7. When the desired setting is shown, press Select. The value stops flashing. If there are additional adjustable settings
on the screen, the next setting flashes. For example, in the date menu, the day, month, and year can be adjusted.
8. Repeat steps 6 and 7 for each setting on the screen.
9. Press the down arrow to step to the next screen.
10. To exit, press the down arrow button until Return is displayed. Press the Select button to exit the menu.
11. Press the AUTO or OFF button to exit the main menu.
Note:
If no buttons are pushed, the controller exits the menus and returns to the generator set status display after 5 minutes.
TP-7092 11/22 43