Country Configuration With Global Wizard - Multi-Tech MT9234ZBA User Manual

Chapter 2 - Installation

Country Configuration with Global Wizard

Different countries have different requirements for how modems must function. Therefore, before you use
your modem, you must configure it to match the defaults of the country in which you are using it. You can
use one of two configuration methods:
•
Using the Global Wizard to Configure Your Modem
•
Using AT Commands to Configure Your Modem
Using the Global Wizard to Configure Your Modem
The Global Wizard configuration utility is recommended for computers running Windows Vista, XP, and
2003. The Global Wizard can configure your modem for a specific country with just a few mouse clicks.
1. Insert the MultiModemUSB CD into the CD-ROM drive. The Autorun dialog box appears.
2. Click Initial Setup and Country Selection.
3. Choose either:
•
Run Global Wizard from CD. This will not load the wizard onto your hard drive, or
•
Install Global Wizard on the HD. This will install the wizard onto your hard drive for future use.
4. The Global Wizard dialog box appears. Click Next.
The Global Wizard searches for your modem and identifies it. Click Next.
5.
6. Select the country in which the modem will be used, and then click Next.
7. Review your choice of country. If it is correct, click Next to configure the modem.
When Global Wizard announces that the parameters have been set, click Finish to exit.
8.
22
Multi-Tech Systems, Inc. MT9234ZBA-USB User Guide (S000419B)