Multi-Tech MT9234ZBA User Manual page 40

Appendix E – Linux Installations
Build and Install the TI USB Driver from the TGZ Package
You will need the TI USB tgz package for this step. The Introduction section above describes where to find the latest TI
USB tgz package.
Log in as root and do the following:
Command
1. tar xvzf ti_usb-X.Y.tgz
2. cd ti_usb-X.Y
3. ./configure
4. make
5. make install
If there are problems in this process, you may need to go back to install and prepare the kernel sources as described
above.
Load the TI USB Driver
The ti_usb driver should be automatically loaded when you plug in the TI USB 3410 device, provided your device uses
the default vendor and product ids. If it does not, see the section entitled "VENDOR and PRODUCT IDS" in the Release
Notes file for Linux 2.4 kernel installations (on the product CD as file name ti_usb_release_notes-1 2.txt).
The first TI USB 3410 device plugged in will appear as /dev/ttyTIUSB0, the next as /dev/ttyTIUSB1, and so on.
Note that these device names are different from the device names used by the Linux usbserial driver. See the section
below entitled "DEVICE FILES" for more information.
If TI USB devices had been in use before installing the new TI USB driver, old versions of the drivers will still be loaded.
These old versions must be unloaded before the newly installed driver will be used.
The simplest way to unload the old drivers and load the new is to reboot.
Alternatively, you can close all open TI USB serial ports, disconnect the TI USB serial devices, and then unload the old TI
USB serial driver with the command
rmmod ti_usb
Completion.
Then reconnect the TI USB serial devices and the new driver will be loaded.
40
Explanation
Un-package the files.
Configure the package for your distribution and
kernel.
Build the driver.
Install the ti_usb driver.
Multi-Tech Systems, Inc. MT9234ZBA-USB User Guide (S000419B)