Multitech MT64DSU Owner's Manual page 42

MT64DSU Owner's Manual
S-Registers
Certain configurations are stored in memory registers called,
S-Registers. The S command is used to assign a value to, and to
read the current value of an S-Register. To assign a value to an S-
Register, enter the letter S , followed by the S-Register number and
an equals sign ( = ). To read an S-Register value, enter the letter S
followed by the S-Register number and a question mark ( ? ), then hit
RETURN (e.g., ATS8?<CR> ). You should receive a response of the
assigned value given to that S-Register. Options shown in boldface
represent the factory default settings.
S0 Auto-Answer
S0 = 0
S0 = 1
S0 = 2
S1 Number of Redials
S1 =
S2 Sync DTE Dialing
S2 = 0
S2 = 1
S2 = 2
S2 = 3
S3 Auto-Disconnect
S3 = 0
S3 = 1
S3 = 2
S3 = 3
S3 = 4
S3 = 5
S3 = 6
S3 = 7
42
Auto-Answer Disabled
Auto-Answer Enabled
Auto-Answer under DTR control
0 through 99 (user selectable)
Sync DTE Dialing Disabled
Dial on DTR transition from low-to-high
V.25bis sync dialing enabled
V.25bis or DTR
Disconnect when DTR drops
Disconnect after 10 minutes of data inactivity
Disconnect after 30 minutes of data inactivity
Disconnect after 60 minutes of data inactivity
Disconnect when DTR drops or after 0 minutes of
data inactivity
Disconnect when DTR drops or after 30 minutes
of data inactivity
Disconnect when DTR drops or after 60 minutes
of data inactivity
Auto-Disconnect Disabled