OBD10M-R2000-4EP-V1V17
Commissioning
6.
Click OK to confirm.
DHCP
Connecting via DHCP requires the availability of a DHCP server, such as a router,
on the local network; see Auto IP, PC network card settings.
If this requirement is fulfilled, you can set the sensor to DHCP.
Configuring a Connection via DHCP
1.
Under Ethernet Setup > Address Mode, set the sensor to "DHCP."
2.
Restart the sensor to apply the configuration.
12
After approx. 30 seconds, Microsoft® Windows® assigns an auto IP for the
PC.