Multitech RouteFinder RF820 Reference Manual page 8

Step 3 – VPN Setup
1. Go to the VPN > IPSec screen.
2. Click the VPN Status check box to enable IPSec. Then click the Save button.
3. Select Add an IKE Connection by clicking the corresponding Add button.
The Add an IKE Connection screen displays. All settings can be left at the default unless
otherwise indicated:
1. Connection Name: Enter in the name of the VPN tunnel you want to create. Example: vpn-
client.
2. Secret: Enter in the Secret (which has to match on both ends of the tunnel)
3. Local WAN IP: Select WAN1
4. Local LAN: Select LAN
5. Remote LAN: Select vpn-client. Note that you select Any if the Remote Client is dynamic.
6. Click the Save button to save your tunnel.
Multi-Tech Systems, Inc. RF820/830 IPSec VPN Setup Examples – A Reference Guide
Chapter 1 – Non-NAT Setup Examples
8