Sun Microsystems SPARCstorage Library Installation Manual page 30

4
4-4
2. Plug the female end of the power cord into the power receptacle at the
rear of the tape library.
See Figure 4-3.
Power cord receptacle
Figure 4-3 Location of the Power Receptacle on the SPARCstorage Library
3. Route the power cord down the right side and along the bottom of the
cabinet.
4. Route the power cord up through the cut-out to the power distribution
unit at the side of the cabinet.
5. Plug the power cord for the tape library into the power distribution unit
See Figure 4-4 and Figure 4-5.
Warning – The power distribution unit serves as the primary disconnect
device for the SPARCstorage Library. Do not plug the tape library into a power
source other than the power distribution unit. Personal injury may result if you
work on a tape library that is plugged into another power source, since that
power source may still be active when you work on the tape library.
SPARCstorage Library Installation Manual—February 1995