Sun Microsystems SPARCstorage Library Installation Manual page 37

Table 4-1 Default SCSI IDs for the SPARCstorage Library, the Tape Drives, and the
Host
Device/Unit
Tape drive (first)
Tape drive (second)
Computer system
(host) or SCSI host
adapter SBus card
Under the Solaris 2.x software environment, you can set the SCSI IDs of the
tape drives and of the tape library to any SCSI ID available from 0 to 6. SCSI
IDs 4 and 5 are most commonly used for tape drives. SCSI IDs 1 and 2 are good
choices for the robotic portion (LIB) of the tape library. SCSI ID 7 is reserved
for the host or the SCSI host adaptor card.
Caution – The tape library and each installed tape drive must have an unique
!
SCSI ID.
To view or change the SCSI IDs:
1. Locate the LCD and keypad on the front panel.
2. Press Escape until the Primary Menu is displayed.
3. Select the Configuration Menu by pressing
4. Select Set SCSI IDs by pressing
5. Set the SCSI IDs for Drive 1 (the inner tape drive), Drive 2 (the outer tape
drive), and the tape library (LIB).
• Press either
←
• Press
• Press Enter to make the selection active, or Escape to not change anything.
Installing the SPARCstorage Library
SCSI ID Description
4 Inner tape drive
5 Outer tape drive
7 Allows the host to act as the initiator of
commands on the SCSI bus.
↑
↑ ↓
or to increase or decrease the SCSI ID value.
→
or to select a drive or the tape library.
↑ ↓
or , then pressing Enter.
↓
or , then pressing Enter.
4
4-11