In Case Of Problem - Midea MID45S201-HR Instruction Manual

IN CASE OF PROBLEM

Before calling the service
See the tables on the following pages, because they may contain a solution to the problem without
calling the service.
An issue
The washing machine does not
includes
Water does not flow out
from the washing machine
Foam in the tub
washing machines
Possible causes
The fuse has blown or
blown.
The power supply is not
included.
Low water pressure
The door is not properly
closed.
It's a drain hose
sharply bent.
The filter is clogged.
It is the kitchen sink
clogged.
Not responding
detergent.
26
Solution
Replace the fuse or replace it. Disconnect
all appliances connected to the same
circuit as the washing machine.
Make sure that the dishwasher is switched on
and that the door is properly closed.
Make sure the power cord is properly
connected to the wall outlet.
Check that the washing machine is
properly connected to the water supply
and that the tap is open.
Be sure to close the door tightly.
Check the drain hose.
Check the filter system.
Check that the water can flow freely
through the drain. If the problem is
a clogged kitchen sink, you may
need a plumber, not a washing
machine repairman.
Use only a special detergent for washing
dishes in a machine so that foam does not
form. If this happens, open the dishwasher
and let the suds evaporate. Add about 1 L of
cold water to the bottom of the dishwasher.
Close the dishwasher, then select any cycle.
First, the washing machine will drain the
water. Open the door after emptying and
check if the foam has disappeared. Repeat if
necessary.