Midea MID45S201-HR Instruction Manual page 24

Step 4 Steps of installing the washing machine
Pay attention to the installation steps indicated in the installation
drawings.
1.Stick anti-condensation tape under the bottom of the element. Make sure it is flush
with the edge of the element. (Step 2)
2.Connect the supply hose to the cold water supply.
3.Connect the drain hose.
4.Connect the power cable.
5.Place the dishwasher in the kitchen unit.
6.Level the washing machine. The rear foot can be adjusted from the front of the washing machine by
turning the cross screw in the middle of the base of the washing machine with a cross screwdriver.
Use a flat screwdriver to adjust the front legs. Use it to turn the legs until the washing machine is
level. (Step 5 – 6)
7.Place the element door on the outside of the washing machine door. (Step 7 – 10)
8.Adjust the tension of the door springs with a Phillips screwdriver; turn it clockwise to
tighten the left and right springs. Failure to do so may damage the washing
machine. (Step 11)
9.The washing machine must be firmly fixed in place. There are two ways to do it:
AND.Standard work surface: Insert the installation hook into the slot on the side
and fasten it to the work surface with wood screws.
B.Marble or granite worktop: Fasten the side with screws.
AND
B
24