Table of Contents
Advertisement
Figure 53. Dust filter installation
After you install the dust filter, complete the following steps:
1. Install the node if needed (see "Install a compute node" on page 58).
2. Reconnect power cords and all external cables.
Fan replacement
Use the following information to remove and install the fan.
Remove a fan
Use this information to remove a fan.
To avoid possible danger, read and follow the following safety information.
S002
CAUTION:
The power control button on the device and the power switch on the power supply do not turn off the
electrical current that is supplied to the device. The device also might have more than one power
cord. To remove all electrical current from the device, ensure that all power cords are disconnected
from the power source.
S009
CAUTION:
To avoid personal injury, disconnect the fan cables before removing the fan from the device.
Before you remove a fan, complete the following steps:
1. Read the following sections to ensure that you work safely.
• "Safety" on page iii
• Chapter 4 "Hardware removal, installation and management guidelines" on page 27
ThinkAgile MX Certified Node Small FactorThinkAgile MX1021User Guide
68
Advertisement
Table of Contents
