Table of Contents
Advertisement
2. Turn off the server. Disconnect the power cords and all external cables (see "Turn off the server" on
page 32).
3. Depends on the environment of the server, check the status of the dust filter every 3 months to make
sure it is functional.
To install the dust filter in locking bezel, complete the following steps:
Watch the procedure. A video of the process is available:
• Youtube:
https://www.youtube.com/playlist?list=PLYV5R7hVcs-A25P7vBoGa_wn7D7XTgDS_
• Youku:
http://list.youku.com/albumlist/show/id_50483444
Step 1.
Align the dust filter with the slot in locking bezel, and place the filter into the slot.
Figure 50. Dust filter installation
Step 2.
Rotate the dust filter holder into the slot until it clicks.
Figure 51. Dust filter installation
After you install the dust filter in locking bezel, complete the following steps:
1. Install the node if needed (see "Install a compute node" on page 58).
2. Reconnect power cords and all external cables.
Remove the dust filter in E1 enclosure bracket
Use this information to remove the dust filter in E1 enclosure bracket.
Before you remove the dust filter in E1 enclosure bracket, complete the following steps:
ThinkAgile MX Certified Node Small FactorThinkAgile MX1021User Guide
66
Advertisement
Table of Contents
