Table of Contents
Advertisement
Chapter 5. Hardware replacement procedures
This section provides installation and removal procedures for all serviceable system components. Each
component replacement procedure references any tasks that need to be performed to gain access to the
component being replaced.
For more information about ordering parts:
https://datacentersupport.lenovo.com/products/servers/thinksystem/se350/parts
Note: If you replace a part, such as an adapter, that contains firmware, you might also need to update the
firmware for that part.
Adapter replacement
Use the following information to remove and install an adapter.
Remove a M.2 data adapter
Use this information to remove a M.2 data adapter.
Before you remove a M.2 data adapter, complete the following steps:
1. Read the following sections to ensure that you work safely.
• "Safety" on page iii
• Chapter 4 "Hardware removal, installation and management guidelines" on page 27
2. Turn off the server. Disconnect the power cords and all external cables (see "Turn off the server" on
page 32).
3. Remove the node from the enclosure if needed (see "Remove a compute node" on page 55).
4. Remove the PCIe riser assembly (see "Remove the PCIe riser assembly" on page 77 for instructions).
To remove a M.2 data adapter, complete the following steps:
Watch the procedure. A video of the process is available:
• Youtube:
https://www.youtube.com/playlist?list=PLYV5R7hVcs-A25P7vBoGa_wn7D7XTgDS_
• Youku:
http://list.youku.com/albumlist/show/id_50483444
Step 1.
Remove the screws on the both side to remove the bezels from the riser assembly.
© Copyright Lenovo 2020
43
Advertisement
Table of Contents
