Table of Contents
Advertisement
1. Read the following sections to ensure that you work safely.
• "Safety" on page iii
• Chapter 4 "Hardware removal, installation and management guidelines" on page 27
2. Turn off the server. Disconnect the power cords and all external cables (see "Turn off the server" on
page 32).
3. Remove the node from the enclosure if needed (see "Remove a compute node" on page 55).
4. It is required to have dust filter when server is in operation.
To remove the dust filter in E1 enclosure bracket, complete the following steps:
Watch the procedure. A video of the process is available:
• Youtube:
https://www.youtube.com/playlist?list=PLYV5R7hVcs-A25P7vBoGa_wn7D7XTgDS_
• Youku:
http://list.youku.com/albumlist/show/id_50483444
Step 1.
Remove the dust filter out of the bracket.
Figure 52. Dust filter removal
If you are instructed to return the defective component, please package the part to prevent any shipping
damage. Reuse the packaging the new part arrived in and follow all packaging instructions.
Install the dust filter in E1 enclosure bracket
Use this information to install the dust filter in E1 enclosure bracket.
Before you install the dust filter in E1 enclosure bracket, complete the following steps:
1. Read the following sections to ensure that you work safely.
• "Safety" on page iii
• Chapter 4 "Hardware removal, installation and management guidelines" on page 27
2. Turn off the server. Disconnect the power cords and all external cables (see "Turn off the server" on
page 32).
3. Depends on the environment of the server, check the status of the dust filter every 3 months to make
sure it is functional.
To install the dust filter in E1 enclosure bracket, complete the following steps:
Watch the procedure. A video of the process is available:
• Youtube:
https://www.youtube.com/playlist?list=PLYV5R7hVcs-A25P7vBoGa_wn7D7XTgDS_
• Youku:
http://list.youku.com/albumlist/show/id_50483444
Step 1.
Align the dust filter with the slot in locking bezel, and place the filter into the slot.
.
Chapter 5
Hardware replacement procedures
67
Advertisement
Table of Contents
