Table of Contents
Advertisement
Table 12. System-board jumpers
Jumper name
Serial select jumper
4
Important:
1. Before you change any switch settings or move any jumpers, turn off the server; then, disconnect all
power cords and external cables. Review the information in
safety_documentation/pdf_files.html
guidelines" on page 27, "Handling static-sensitive devices" on page 29, and "Turn off the server" on
page 32.
2. Any system-board switch or jumper block that is not shown in the illustrations in this document are
reserved.
PCIe riser assembly
Use this information to locate the connectors on the PCIe riser assembly.
PCIe and M.2 riser assembly
Figure 15. PCIe and M.2 riser assembly
Table 13. PCIe and M.2 riser assembly
Slot 6: PCIe 3.0 x16, (supports <75W, low profile, half-
1
height, half-length PCIe adapter)
ThinkAgile MX Certified Node Small FactorThinkAgile MX1021User Guide
20
Jumper setting
• Pins 1 and 2: Send UEFI debug message to serial port (default)
• Pins 2 and 3: Sends the XCC to the serial port.
, Chapter 4 "Hardware removal, installation and management
Drives (Slot) 2-5, M.2 data adapters
2
http://thinksystem.lenovofiles.com/help/topic/
Advertisement
Table of Contents
