Quick Start; Getting Started - ST STM32 Nucleo User Manual

5

Quick start

This section describes how to quickly start development using NUCLEO-C031C6.
To use the product, the user must accept the Evaluation Product License Agreement from the
webpage.
For more information on the STM32 Nucleo-64 board and demonstration software, visit the
stm32nucleo webpage.
5.1

Getting started

Follow the sequence below to configure the STM32 Nucleo-64 board and launch the demonstration application
(Refer to Figure 3
1. Check jumper positions on board: CN2 ST-LINK [1-2] and [3-4], JP5 PWR [1-2], and JP6 ON.
2. For correct identification of all device interfaces from the host PC, install the Nucleo USB driver available on
the www.st.com/stm32nucleo
3. To power the board, connect the STM32 Nucleo-64 board to a PC with a USB Type-A or USB Type-C
Micro-B cable through the CN1 USB connector. Once powered on, the LD3 PWR green LED lights up and
LD1 COM LED blinks.
4. Press the B1 blue user button.
5. Observe that the blinking frequency of the LD4 three green LEDs changes, by clicking on the B1 button.
6. The demonstration software and several software examples showing how to use the STM32 Nucleo features
are available from the
UM2953 - Rev 1
for component location):
web page, before connecting the board.
NUCLEO-C031C6 product location.
UM2953
Quick start
www.st.com/epla
www.st.com/
®
to
page 6/32